The
CRL LS6BS Transom/Sidelite Support Bracket is used to support the leading edge of a glass transom over a single door. Comes with both Flush Mount and Surface Mount Fasteners.
NOTE: The following guidelines are to be used when making a door using this hardware:
Maximum Height: 98-1/2" (2500 mm)
Maximum Weight: 176 Lbs. (80 kg)
Maximum Width: 47-1/4" (1200 mm)
If the door exceeds any of these limitations, full door rails should be used.
Product Warning:STRUCTURAL DISCLAIMER - All customers who in any way utilize this product are solely responsible to consult a structural engineer to determine the suitability of the product for the intended use and site conditions. All installers must be qualified and have professional knowledge about compliance with local, state and federal regulations, safety factors, and the appropriate choice of fixing material and procedures.
These fittings are not for use with laminated glass.
Most shipping weights are approximate and have not been verified. If the exact weight is needed in order to determine shipping costs, and shipping costs are required in order for you to complete your order, please request this prior to submitting your order by contacting CRL Customer Service. Product images shown are of the actual product or a close representation. Colors can vary depending on your computer's video card and on how your monitor's color is adjusted.
Stainless Steel Advisory:
Although Stainless Steel is resistant to corrosion, it is not rust or stain proof. CRL recommends periodic maintenance to help maintain its factory finish. For more information, view the Stainless Steel Disclaimer found in the Technical References section below.
Print