• Great for Surfacing the Bottom of Vases or Cast Free form Shapes
• One Horsepower, 110-220 Volt AC, Single Phase Motor
• Operates on 110 Volts AC

The CRL Horizontal Wet Belt Sander is good for grinding vase bottoms or pottery. It uses standard 4" x 106" (102 mm x 2.69 m) wet/dry abrasive belts that are driven directly by a one horsepower, single phase motor. The Steel Pulleys and Tightening Device are taken from the CRL Cat No. 2200RP Vertical 106" Machine design. Water is sprayed onto the belt to keep heat and grinding dust down. There is a Flat Platen behind the belt at the drive end of the tank.

Product Warning:

Not available for shipment to Australia. Always wear the proper safety gear; ES15030, ES285X when using any type of power tool. A ground fault circuit interrupt GF1 should be used with any type of wet working electric tool.