• 2-3/4" (70 mm) Pivot Setback
• For 3/8" or 1/2" (10 or 12 mm) Glass
• Use Monolithic Tempered Glass

CRL Bottom Gate Patch Fittings are used with our bottom door pivots or floor closers. It fits in the lower corner of the gate's glass panel, and requires a hole and cut-out in the glass. Available in brushed stainless steel finish, it comes complete with instructions and a glass cut-out template.

GLASS FABRICATION REQUIRED:
One 3/4" (19 mm) Diameter
Hole and Corner Notch

COMES WITH:
Template and Instructions

Product Warning:

These fittings are not for use with Laminated Glass.

The following guidelines are to be used when making a door using this hardware:
MAXIMUM HEIGHT: 102" (2591MM)
MAXIMUM WEIGHT: 194 LBS (88KG)
MAXIMUM WIDTH: 42" (1092MM)
If the door exceeds any of these limitations, full door rails should be used.